AutoZone 1932 Packard Deluxe 6.3L 2BL 8cyl | Repair Guides | Body | Interior | Moldings & Panels | AutoZone.com

Search suggestions

    My Vehicles

    1932 Packard Deluxe 6.3L 2BL 8cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    CLOSED Open at 7:30 AM

    SAVE 20% ON ONLINE SHIP-TO-HOME ORDERS OF $100 OR MORE.

    Use Code: SEECLEAR

    See Details

    Ford Crown Victoria, Mercury Grand Marquis, Marauder, Lincoln Town Car 1999-2005

    Moldings & Panels

    Print

    Removal & Installation



    Door Panel
    1. Disconnect the negative battery cable.
    2.  
    3. Snap out the two door pull strap retaining screw covers. Remove the screws.
    4.  


    CAUTION
    To avoid breakage of the door pull covers, insert a small screwdriver diagonally between the pull strap and chrome bracket. Snap out both sides then remove.

    1. Remove the two screws on the front and rear side of the front door trim panel.
    2.  
    3. Using the trim pad removing tool, pry the trim panel retaining clips from the door inner panel.
    4.  


    NOTE
    Do not use the front door trim panel to remove the trim clips from the door inner panel. Replace any bent, damaged or missing push pins.

    1. Remove the window regulator switch housing from the back of the front door trim panel. Lift up the housing and disconnect all connectors from the switch housing.
    2.  
    3. Disconnect the driver seat regulator control processor switch if equipped.
    4.  
    5. Twist out the interior lamp wire assembly.
    6.  

    To install:

    1. Ensure that the plastic watershield is secured to the door .
    2.  
    3. Position the front door trim panel to the door. Connect the interior lamp wiring.
    4.  
    5. Align door lock side to its mating slide on the sheet metal.
    6.  
    7. Snap in the front door trim panel. Ensure all retainers fit properly. Install the two retaining screws on the front and rear side of the front door trim panel.
    8.  
    9. Connect the driver seat regulator control processor, if equipped.
    10.  
    11. Position the window regulator control switch housing and connect the switch connectors. Install it to the front door trim panel by snapping it in, or by installing the screw at the rear.
    12.  
    13. Install the two retaining screws and pull strap covers.
    14.  
    15. Connect the negative battery cable.
    16.  



    Click image to see an enlarged view

    Fig. Front door panel-1992-00 vehicles



    Click image to see an enlarged view

    Fig. Rear door panel-1992-00 vehicles

     
    AutoZone Logo