AutoZone 2000 Chevrolet Lumina 3.1L SFI OHV 6cyl | Repair Guides | Fuel System | Fuel Level Sending Unit | Removal & Installation | AutoZone.com

Search suggestions

    My Vehicles

    2000 Chevrolet Lumina 3.1L SFI OHV 6cyl

    Find a Store

    Select Store

    SAVE 20% + GET A $10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OVER $100.

    Use Code: 20STACK10

    See Details

    HHR 2006-2008

    Removal & Installation

    Print


    CAUTION
    Never drain or store fuel in an open container. Always use an approved fuel storage container in order to reduce the chance of fire or explosion.


    CAUTION
    Place a dry chemical (Class B) fire extinguisher nearby before performing any on vehicle service procedures. Failure to follow these precautions may result in personal injury.


    NOTE
    The fuel level sending unit is integral with the fuel pump assembly in the fuel tank. See Fuel Pump removal and installation in the Fuel section.

    1. Before servicing the vehicle, refer to the Precautions Section.
    2.  
    3. Relieve the fuel system pressure.
    4.  
    5. Disconnect the negative battery cable.
    6.  
    7. Remove the fuel tank, as outlined in the Fuel Section.
    8.  
    9. Using the special tool J 45722, unlock the fuel sender lock ring.
    10.  
    11. Slowly lift the fuel pump flange up until the quick connect fittings and fuel level sensor electrical connector are just visible.
    12.  
    13. Disconnect the fuel level sensor electrical connector from the fuel pump flange.
    14.  
    15. Disconnect the fuel tank vent valve and the fuel filter quick connect fittings from the fuel pump flange.

      Click image to see an enlarged view

      Fig. Exploded view of fuel tank with fuel pump flange lock & seal

    16.  
    17. Remove the fuel pump flange lock ring (1) and fuel pump flange (2). If required, remove the lock ring from the flange.
    18.  
    19. Remove and discard the fuel pump flange seal (3).

      Click image to see an enlarged view

      Fig. Fuel level sensor retainer (2) squeezed together in order to remove the fuel level sensor

    20.  
    21. Squeeze the sides of the fuel level sensor retainer (2) together in order to remove the fuel level sensor.
    22.  
    23. Remove the fuel level sensor from the fuel pump module by sliding the sensor up.
    24.  

    To install:

    1. Position the fuel level sensor into the fuel pump module and slide the sensor down.
    2.  
    3. Ensure that the fuel level sensor retainer (2) is fully engaged with the fuel pump module.
    4.  
    5. Position a NEW fuel pump flange seal onto the fuel tank.
    6.  
    7. Position the fuel pump flange and lock ring over the fuel tank opening.
    8.  
    9. Ensure that the fuel pump flange tab is aligned with the arrow on the fuel tank.
    10.  
    11. Connect the fuel tank vent valve and the fuel filter quick connect fittings to the fuel pump flange.
    12.  
    13. Connect the fuel level sensor electrical connector to the fuel pump flange.
    14.  
    15. Slowly lower the fuel pump flange into the fuel tank.
    16.  
    17. Using the special tool, J 45722, lock the fuel sender lock ring.
    18.  
    19. Install the fuel tank.
    20.  

     
    AutoZone Logo