AutoZone | Repair Guides | Fuel System | Fuel Injection System | Inertia Fuel Shutoff Switch | AutoZone.com

Search suggestions

    My Vehicles

    Add a Vehicle

    Find a Store

    Select a Store

    SAVE 15% ON SHIP TO HOME ORDERS of $75 or more!

    Use Code: AZ15OFF75

    See Details

    Mercury Villager Nissan Quest 1997-2000

    Inertia Fuel Shutoff Switch

    Print

    GENERAL INFORMATION

    The inertia fuel shutoff switch turns off power to the electric fuel pump in the event of a collision. Once the switch has been tripped, it must be reset manually in order to start the engine.

    The inertia switch is located in the driver's side kick panel in the passenger compartment.

    RESETTING THE SWITCH
    1. Turn the ignition switch OFF .
    2.  
    3. Ensure that there is no fuel leaking in the engine compartment, along any of the fuel and vapor lines, or at the tank. There should be no odor of fuel as well.
    4.  
    5. If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.
    6.  
    7. Without starting the engine, cycle the ignition switch from the OFF to ON positions several times, allowing five seconds at each position, to build fuel pressure within the system.
    8.  
    9. Again, check the fuel system for leaks. There should be no odor of fuel as well.
    10.  
    11. If there is no leakage and/or odor of fuel, it is safe to operate the vehicle, however, it is recommended that the entire system be checked by a professional, especially if the vehicle was in an accident severe enough to trip the inertia switch.
    12.  



    Click image to see an enlarged view

    Fig. The inertia switch reset button is located on the top of the switch



    Click image to see an enlarged view

    Fig. Inertia fuel shutoff switch location

    removal & installation
    1. Disconnect the negative battery cable.
    2.  
    3. Remove the driver's side front scuff plate. This is the panel on the body at the bottom of the door. There are four retaining clips that hold the plate in place. Pull up on the plate to remove it.
    4.  
    5. Remove the driver's side kick panel to gain access to the inertia fuel shutoff switch. Pull out on the panel to release the clips.
    6.  
    7. Remove the two inertia fuel shutoff switch screws.
    8.  
    9. Disconnect the inertia fuel shutoff switch electrical connector.
    10.  
    11. Remove the switch from the vehicle.
    12.  
    13. The installation is the reverse of removal.
    14.  



    Click image to see an enlarged view

    Fig. Remove the driver's side scuff plate



    Click image to see an enlarged view

    Fig. Pull up the door weather strip, then . . .



    Click image to see an enlarged view

    Fig. . . . remove the driver's side kick panel to gain access to the inertia fuel shutoff switch



    Click image to see an enlarged view

    Fig. Removing the inertia fuel shutoff switch screws

     
    AutoZone Logo

    Returning Customers

    Create an Account