AutoZone 1995 Eagle Vision TSI 3.5L MFI 6cyl | Repair Guides | Engine Mechanical | Engine Mechanical Components | Torque Strut | AutoZone.com

Search suggestions

    My Vehicles

    1995 Eagle Vision TSI 3.5L MFI 6cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    CLOSED Open tomorrow at 7:30 AM

    Save 20% Sitewide

    Use Code: YOUCHOOSE20

    See Details

    Get A $25 Gift Card

    Use Code: YOUCHOOSE25

    See Details

    PT Cruiser, 2001 - 2005

    Torque Strut

    Print

    Adjustment



    1. The upper and lower torque struts need to be adjusted together to assure proper engine positioning and engine mount loading. Whenever a torque strut bolt(s) is loosened, this procedure must be performed.
    2.  
    3. Remove accessory drive belt splash shield.
    4.  
    5. Remove pencil strut.
    6.  
    7. Loosen the upper and lower torque strut attaching bolt at the suspension crossmember and shock tower bracket.
    8.  
    9. The engine position may now be adjusted by positioning a suitable floor jack on the forward edge of the transmission bell housing.
      NOTE
      The floor jack must be positioned as shown in to prevent minimal upward lifting of the engine.

    10.  
    11. With the engine supported, remove the upper and lower torque strut attachment bolt(s) at shock tower bracket and suspension crossmember. Verify that the torque struts are free to move within the shock tower bracket and crossmember. Reinstall the torque strut bolt(s), but do not tighten.
    12.  
    13. Carefully apply upward force, allowing the upper engine to rotate rearward until the distance between the center of the rearmost attaching bolt on the engine mount bracket (point -A-) and the center of the hole on the shock tower bracket (point -B-) is 4.70 inches (119 mm).
      WARNING
      The engine must be held in position with jack until both the upper and lower torque strut bolts are tightened.

    14.  
    15. With the engine held at the proper position, tighten both the upper and lower torque strut bolts to 85 ft. lbs. (115 Nm).
    16.  
    17. Remove the floor jack.
    18.  
    19. Install pencil strut and tighten nuts to 43 ft. lbs. (58 Nm).
    20.  
    21. Install accessory drive belt splash shield.
    22.  

     
    AutoZone Logo