AutoZone 2006 Pontiac G6 GTP 3.9L SFI 6cyl | Repair Guides | Chassis Electrical | Windshield Wipers And Washers | Windshield Washer Pump | AutoZone.com

Search suggestions

    My Vehicles

    2006 Pontiac G6 GTP 3.9L SFI 6cyl

    Find a Store

    Select Store

    Save 20% Sitewide

    Use Code: YOUCHOOSE20

    See Details

    Get A $25 Gift Card

    Use Code: YOUCHOOSE25

    See Details

    Toyota Camry and Avalon 1997-2000

    Windshield Washer Pump

    Print

    REMOVAL & INSTALLATION

    The windshield washer reservoir motor (pump) is located in the washer reservoir. The same pump is used for the front and rear washers.

    1. Disconnect the negative battery cable.
    2.  
    3. Remove the washer reservoir/motor assembly from the vehicle.
    4.  



    Click image to see an enlarged view

    Fig. Unbolt the washer reservoir . . .



    Click image to see an enlarged view

    Fig. . . . then lift it out to access the wiring and hoses

    1. Separate the washer fluid motor wiring from the harness.
    2.  



    Click image to see an enlarged view

    Fig. Separate the wiring at the pump motor

    1. Pull the motor from the rubber grommet retaining it to the washer reservoir.
    2.  



    Click image to see an enlarged view

    Fig. Pull the motor from the grommet in the reservoir

    To install:

    1. Inspect the rubber grommet for deterioration and replace if necessary.
    2.  
    3. Apply petroleum jelly to the motor before inserting it into the grommet.
    4.  
    5. Attach the harness to the pump.
    6.  
    7. Secure the washer reservoir into the engine compartment.
    8.  
    9. Connect the negative battery cable and test the washer pump for operation.
    10.  

     
    AutoZone Logo