AutoZone Product & HowTo Info | |

Search suggestions

    My Vehicles

    Add a Vehicle

    Find a Store

    Select Store

    SAVE 20% + GET A $10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OVER $100.

    Use Code: 20STACK10

    See Details

    Oil Pressure Switch

    Inspect/Test

    Oil pressure can be checked at the sending unit passage with an externally mounted mechanical oil pressure gauge. To get accurate results from the test, make sure you follow the manufacturer's recommendations and compare your findings to specifications.

    Testing the Oil Pressure Gauge

    • Test the gauge by grounding the wire that leads to the sending unit on the block.
    • When the wire is disconnected from the sending unit with the key switch on, the needle on the oil pressure gauge should be either all the way high or all the way low. Grounding the wire should make the needle move to the opposite side of the gauge from where it was before the wire was grounded. If the vehicle is equipped with an oil pressure light, touching the wire to ground and then removing the wire from ground should turn the light on and off.
    • If either happens, the gauge and wiring are good and the sending unit is at fault.

    Testing Oil Pressure

    Pressure can be tested by temporarily installing an oil pressure gauge in place of the sending unit. Before testing, look up the oil pressure specifications for your vehicle in the appropriate service manual.

    • Bring the engine up to operating temperature.
    • Now shut the engine off.
    • Locate the oil pressure sending unit; usually it is on the lower side of the engine block.
    • Disconnect the wire from the sending unit and use an open ended wrench to remove the sender. using pliers can damage the unit.
    An oil pressure sending unit is removed with a special socket. Courtesy of Chrysler Corporation.
    • Tighten the oil pressure test gauge into the hole in the block where the sender was removed.
    Measuring oil pressure. Reprinted with permission.
    • Check the engine's oil level and fill, if required.
    WARNING
    Be extremely careful when working near a running engine. Always wear safety goggles or glasses with side shields when working around moving machinery and be sure that your clothing is not loose.
    • Now turn the engine on and check the oil pressure on the gauge.
      • Watch as the engine warms to note any excessive drops due to temperature.
      • Make sure the engine speed is set to specifications for testing pressure.
      • If necessary, use a tachometer and adjust the engine idle speed.
    • Record the measured oil pressure, then turn off the engine.
    • Compare the test results with the manufacturer's specifications.
      • If the oil pressure is within specifications, this shows that the oil pressure sending unit may not be working correctly.
      • In many cases, replacing the oil sending unit will correct the problem.
    • After the test is complete, reinstall the oil pressure sending unit, start the engine, and confirm there are no leaks.

    AutoZone Logo