AutoZone 1998 Honda Prelude 2.2L MFI VTEC 4cyl | Repair Guides | Suspension And Steering | Steering | Power Steering Pump | AutoZone.com

Search suggestions

    My Vehicles

    1998 Honda Prelude 2.2L MFI VTEC 4cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    CLOSED Open tomorrow at 7:30 AM

    Save 20% Sitewide

    Use Code: YOUCHOOSE20

    See Details

    Get A $25 Gift Card

    Use Code: YOUCHOOSE25

    See Details

    GM Lumina/Silhouette/Transport APVs 1990-1999 Repair Guide

    Power Steering Pump

    Print

    REMOVAL AND INSTALLATION



    1. Disconnect the negative battery cable.
    2.  
    3. Disconnect and cap the power steering pump hoses.
    4.  
    5. Remove the accessory drive belt.
    6.  
    7. Remove the power steering pump pulley using a suitable puller tool.
    8.  
    9. Remove the pump mounting bolts and remove the pump from the vehicle.
    10.  

    See Figures 1, 2 and 3

    Click image to see an enlarged view

    Fig. Fig. 1: On some vehicles, you must use a puller to remove the power steering pump pulley



    Click image to see an enlarged view

    Fig. Fig. 2: Power steering pump mounting-early model vehicle shown



    Click image to see an enlarged view

    Fig. Fig. 3: Power steering pump mounting-late model vehicle shown

    1. Installation is the reverse of the removal procedure. Tighten the pump mounting bolts to 18 ft. lbs. (25 Nm).
    2.  
    3. Bleed the power steering system to remove trapped air. Air in the system could cause noise and or damage to the pump.
    4.  

    BLEEDING



    This procedure requires the help of an assistant.

    1. With the engine OFF, the wheels off the ground and turned all the way to the left, fill the fluid reservoir to the FULL COLD mark on the fluid level indicator.
    2.  
    3. With an assistant checking the fluid level and condition, bleed the system by turning the wheels from side to side without hitting the stops. You should repeat this at least 20 times, making sure to keep the fluid level at the FULL COLD mark.
    4.  

    Fluid with air in it has a light tan appearance. This air must be eliminated from the fluid before normal steering action can be obtained.

    See Figure 4

    Click image to see an enlarged view

    Fig. Fig. 4: Power steering bleeding procedure

    1. Start the engine, and while it is idling, recheck the fluid level and add as necessary to reach the FULL COLD mark.
    2.  
    3. Return the wheels to the center position. Lower the front wheels to the ground and continue running the engine for 2 or 3 minutes.
    4.  
    5. Road test the vehicle to make sure the steering functions properly and is free of noises.
    6.  

    See Figure 5

    Click image to see an enlarged view

    Fig. Fig. 5: Torque specification

     
    AutoZone Logo