AutoZone 1992 Dodge/Ram Truck Grand Caravan 4WD 3.3L MFI 6cyl | Repair Guides | Brakes | Anti-lock Brake System | Electronic Brake Control Module (ebcm) | AutoZone.com

Search suggestions

    My Vehicles

    1992 Dodge/Ram Truck Grand Caravan 4WD 3.3L MFI 6cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    OPEN 'til 10:00 PM today

    Save 20% Sitewide

    Use Code: YOUCHOOSE20

    See Details

    Get A $25 Gift Card

    Use Code: YOUCHOOSE25

    See Details

    GM Century/Lumina/Grand Prix/Intrigue 1997-2000

    Electronic Brake Control Module (EBCM)

    Print

    The controlling element of the ABS system is a microprocessor-based Electronic Brake Control Module (EBCM). If the vehicle is equipped with traction control, the microprocessor is called the Electronic Brake Traction Control Module (EBTCM). Inputs to the system include four wheel speed sensors, the brake switch, ignition switch and unswitched battery voltage. Outputs include three bi-directional motor controls, four indicator controls, two solenoid controls, and the system enable relay. A serial data line, located in terminal 9 of the Data Link Connector (DLC), is provided for scan tools.

    The EBCM/EBTCM monitors the speed of each wheel. If any wheel begins to approach lock-up and the brake switch is on, the EBCM/EBTCM controls the motors and solenoids to reduce brake pressure to the wheel approaching lock-up. Once the wheel regains traction, brake pressure is increased until the wheel again begins to approach lock-up. This cycle repeats until either the vehicle comes to a stop, the brake is released, or no wheels approach lock-up. Additionally, the EBCM/EBTCM monitors itself, each input (except the serial data line) and each output for proper operation. If any system malfunction is detected, the EBCM/EBTCM will store a DTC in nonvolatile memory (DTCs will not disappear if the battery is disconnected).


    NOTE
    The EBCM/EBTCM has no serviceable or removable PROM. If defective, the EBCM/EBTCM must be replaced as an assembly.

    REMOVAL & INSTALLATION





    Click image to see an enlarged view

    Fig. The Anti-lock Brake System EBCM (or EBTCM) is located under the steering column, on the left side

    1. Locate the EBCM/EBTCM under the instrument panel, to the left of the steering column.
    2.  
    3. Release the EBCM/EBTCM from its bracket using the pressure tabs.
    4.  
    5. Detach the electrical harness and remove the EBCM/EBTCM from the vehicle.
    6.  
    7. Installation is the reverse of the removal process. Verify that all electrical connections are secure.
    8.  

     
    AutoZone Logo