The coolant temperature sender is located in the following positions:
See Figures 1 and 2
Before going to the trouble of removing the sender from the engine block and testing it, perform the tests presented in the accompanying chart to ensure that it is the sender malfunctioning, and not another part of the circuit.
- Remove the coolant temperature sender from the engine block.
Attach an ohmmeter to the sender unit as follows:
- Attach one lead to the metal body of the sender unit (near the sender unit's threads).
- Attach the other lead to the sender unit's wiring harness connector terminal.
- With the leads still attached, place the sender unit in a pot of cold water so that neither of the leads is immersed in the water. The portion of the sender unit which normally makes contact with the engine coolant should be submerged.
- Measure and note the resistance.
- Slowly heat the pot up (on the stove) to 190-210° F (88-99° C) and observe the resistance of the sender unit. The resistance should evenly and steadily decrease as the water temperature increases. The resistance should not jump drastically or decrease erratically.
- If the sender unit did not function as described, replace the sender unit with a new one.
REMOVAL & INSTALLATION
See Figure 3
- Disconnect the negative battery cable.
- Remove the radiator cap to relieve any system pressure.
- Disconnect the wiring at the sender.
- Remove the coolant temperature sender from the engine.
See Figure 4
- Coat the threads on the sender with Teflon® tape or electrically conductive sealer, then install the sender. Tighten the sender to 107-143 inch lbs. (12-16 Nm).
- Attach the wiring to the sender and connect the negative battery cable.
- If necessary, add antifreeze to replace any lost coolant, then install the radiator cap.