AutoZone 2007 Mazda Truck CX-9 AWD 3.5L FI DOHC 6cyl | Repair Guides | Chassis Electrical | Instruments & Switches | Turn Signal Switch | AutoZone.com

Search suggestions

    My Vehicles

    2007 Mazda Truck CX-9 AWD 3.5L FI DOHC 6cyl

    My Store

    405 N COLLEGE ST
    (479) 443-4043

    OPEN 'til 10:00 PM today

    SAVE 20% + GET A $10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OVER $100.

    Use Code: 20STACK10

    See Details

    Malibu 2001-2005

    Turn Signal Switch

    Print

    Removal & Installation



    1. Disable the Supplemental Inflatable Restraint (SIR) system, as outlined in the Chassis Electrical Section.
    2.  
    3. Remove the steering column trim cover.

      Click image to see an enlarged view

      Fig. Remove the mounting screw (1) from the multifunction switch (2)

    4.  
    5. Remove the mounting screw from the multifunction switch.
    6.  
    7. Remove the multifunction switch from the column.

      Click image to see an enlarged view

      Fig. Disconnect the electrical connectors (3) from the multifunction switch (1)

    8.  
    9. Disconnect the electrical connectors from the multifunction switch.
    10.  

    To install:

    1. Connect the electrical connectors to the multifunction switch.
    2.  
    3. Position the multifunction switch on the steering column while depressing the spring loaded horn pin.
      NOTE
      Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    4.  
    5. Install the mounting screw to the multifunction switch, and tighten the screw to 35 lb inches (4 Nm).
    6.  
    7. Install the steering column trim cover.
    8.  
    9. Enable the SIR system.
    10.  
    11. Ensure that the multifunction switch functions properly.
    12.  

    1. Disable the Supplemental Inflatable Restraint (SIR) system, as outlined in the Chassis Electrical Section.
    2.  
    3. Remove the upper and lower trim covers.
    4.  
    5. Disconnect the electrical connectors.
    6.  
    7. Release the multifunction switch clips from the stalk switch mount, remove the multifunction switch.

      Click image to see an enlarged view

      Fig. The removal and installation of the turn signal switch

    8.  

    To install:

    1. Install the multifunction switch to the stalk switch mount.
    2.  
    3. Connect the electrical connectors.
    4.  
    5. Install the upper and lower trim covers.
    6.  
    7. Enable the SIR system.
    8.  

     
    AutoZone Logo