AutoZone 2006 Pontiac G6 GTP 3.9L SFI 6cyl | Repair Guides | Brakes | Anti-lock Brake System | Bleeding The Abs System | AutoZone.com

Search suggestions

    My Vehicles

    2006 Pontiac G6 GTP 3.9L SFI 6cyl

    Find a Store

    Select Store

    Save 20% Sitewide

    Use Code: YOUCHOOSE20

    See Details

    Get A $25 Gift Card

    Use Code: YOUCHOOSE25

    See Details

    Hyundai Car 1999-05

    Bleeding the ABS System

    Print

    This procedure should be followed to ensure adequate bleeding of air and filling of the ABS unit, brake lines and master cylinder with brake fluid.

    1. Remove the reservoir cap and fill the brake reservoir with brake fluid.
      CAUTION
      If there is any brake fluid on any painted surface, wash it off immediately.


      NOTE
      When pressure bleeding, do not depress the brake pedal. Recommended fluid: DOT3 or DOT4.

    2.  
    3. Connect a clear plastic tube to the wheel cylinder bleeder plug and insert the other end of the tube into a half filled clear plastic bottle.
    4.  
    5. Connect the hi-scan (pro) to the data link connector located underneath the dash panel.
    6.  
    7. Select and operate according to the instructions on the hi-scan (Pro) screen.
      CAUTION
      You must obey the maximum operating time of the ABS motor with the hi-scan (Pro) to prevent the motor pump from burning.

    8.  
    9. Select Hyundai vehicle diagnosis.
    10.  
    11. Select vehicle name.
    12.  
    13. Select Anti-Lock Brake system.
    14.  
    15. Select air bleeding mode.
    16.  
    17. Press "YES" to operate motor pump and solenoid valve.
    18.  
    19. Wait 60 sec. before operating the air bleeding.(If not, you may damage the motor.)
    20.  
    21. Pump the brake pedal several times, and then loosen the bleeder screw until fluid starts to run out without bubbles. Then close the bleeder screw.
    22.  
    23. Repeat step 5 until there are no more bubbles in the fluid for each wheel.
    24.  

     
    AutoZone Logo