2007 Jeep Compass

Verification Test


Specific to:

Jeep Compass 2007-2009

Jeep Patriot 2007-2009

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait 2 minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

The following procedure should be performed using a diagnostic scan tool to verify proper Supplemental Restraint System (SRS) operation following the service or replacement of any SRS component.

  1. During the following test, the battery negative cable remains disconnected and isolated, as it was during the SRS component removal and installation procedures.
  3. Be certain that the diagnostic scan tool contains the latest version of the proper diagnostic software. Connect the scan tool to the 16-way Data Link Connector (DLC) (2). The DLC is located on the driver side lower edge of the instrument panel (1), near the cowl side inner panel (3).

    Click image to see an enlarged view

    Fig. Data Link Connector (DLC) location

  5. Turn the ignition switch to the ON position and exit the vehicle with the scan tool.
  7. Check to be certain that nobody is in the vehicle, then reconnect the battery negative cable. Wait 2 minutes before proceeding.
    Failure to follow these instructions may result in possible serious or fatal injury.

  9. Using the scan tool, read and record the active (current) Diagnostic Trouble Code (DTC) data.
  11. Use the scan tool to read and record any stored (history) DTC data.
  13. If any DTC is found in Step No. 5 or Step No. 6, refer to the appropriate diagnostic information.
  15. Use the scan tool to erase the stored DTC data. If any problems remain, the stored DTC data will not erase. Refer to the appropriate diagnostic information to diagnose any stored DTC that will not erase. If the stored DTC information is successfully erased, go to Step 9.
  17. Turn the ignition switch to the OFF position for about 15 seconds, and then back to the ON position. Observe the airbag indicator in the instrument cluster. It should light for 6-8 seconds, and then go out. This indicates that the SRS is functioning normally and that the repairs are complete. If the airbag indicator fails to light, or lights and stays ON, there is still an active SRS fault or malfunction. Refer to the appropriate diagnostic information to diagnose the problem.