2007 Jeep Compass

Removal & Installation

Print


NOTE
The blower motor is located on the bottom of the passenger side of the HVAC housing. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect and isolate the negative battery cable.
  4.  
  5. If equipped, remove the silencer from below the passenger side of the instrument panel.
  6.  
  7. From underneath the instrument panel, disengage the connector lock and disconnect the instrument panel wire harness connector (1) from the blower motor (2).
  8.  
  9. Remove the 3 screws (3) that secure the blower motor and the wire lead bracket (4), if equipped, to the bottom of the HVAC housing (5).
  10.  
  11. Remove the blower motor from the vehicle.

    Click image to see an enlarged view

    Fig. View of the blower motor assembly

  12.  

To install:

  1. Position the blower motor (2) into the bottom of the HVAC housing (5).
  2.  
  3. Install the 3 screws (3) that secure the blower motor and the wire lead bracket (4), if equipped, to the HVAC housing. Tighten the screws to 10 inch lbs. (1 Nm).
  4.  
  5. Connect the instrument panel wire harness connector (1) to the blower motor and engage the connector lock.
  6.  
  7. If equipped, install the silencer below the passenger side of the instrument panel.
  8.  
  9. Reconnect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo