2007 Jeep Compass

Removal & Installation

Print

Specific to:

Jeep Compass 2007-2009

Jeep Patriot 2007-2009

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove fuel pump module. Refer to Fuel Pump Module, removal & installation.
    NOTE
    Mark the position of the fuel level sensor on the fuel pump module housing prior to removing. The correct position of the wires is critical to proper operation of the fuel level sensor. Mark the position of the wires prior to removing.

  4.  
  5. Use a terminal removal tool and remove the negative electrical wire from the fuel level sensor.
  6.  
  7. Remove the positive electrical wire from the fuel level sensor.
  8.  
  9. Remove the fuel level sensor retaining tabs from the fuel pump module housing.
  10.  

To install:


NOTE
Correctly position the fuel level sensor to the fuel pump module housing, using the mark made during the removal procedure. Correctly install the positive and negative electrical wires to the fuel level sensor.

  1. Correctly position the fuel level sensor retaining tabs to the fuel pump module housing. Press to lock the fuel level sensor into place on the fuel pump module.
  2.  
  3. Install the positive electrical wire to fuel level sensor.
  4.  
  5. Install the negative electrical wire to fuel level sensor.
  6.  
  7. Install the fuel pump module. Refer to Fuel Pump Module, removal & installation.
  8.  

 
label.common.footer.alt.autozoneLogo