300, 300C & Magnum 2006-2008, Charger 2006-2008

Antenna

Print

Power Antenna



Removal & Installation
Antenna Motor

NOTE
This procedure covers the removal and installation of the antenna module. The antenna module is an electronic circuit component designed to capture and enhance RF (Radio Frequency) signals in both the AM and FM broadcast bands. The antenna module is mounted to the right C-pillar (sedan) or rear liftgate (wagon). The module is grounded through the mounting bracket and fastener. The module has a two wire electrical connector that connects to the integral radio antenna and EBL grid, located on the rear window. There is also an electrical connector for battery voltage and a coax cable connector.

Sedan

NOTE
A battery reconnect procedure must be performed anytime the battery has been disconnected.

  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove C-pillar upper trim.
  4.  
  5. Disconnect wire harness connectors and antenna cable.
  6.  
  7. Remove mounting fasteners and antenna module.

    Click image to see an enlarged view

    Fig. Antenna module location-sedan

  8.  

To install:

  1. Position the module into place.
  2.  
  3. Install and tighten the mounting fasteners.
  4.  
  5. Connect the wire harness connectors and antenna cable to antenna module.
  6.  
  7. Install the C-pillar upper trim.
  8.  
  9. Connect the battery negative cable.
  10.  

Wagon

NOTE
A battery reconnect procedure must be performed anytime the battery has been disconnected.

  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the liftgate trim, as outlined in this section.
  4.  
  5. Disconnect wire harness connectors and antenna cable.
  6.  
  7. Remove mounting fasteners and antenna module.

    Click image to see an enlarged view

    Fig. Antenna module location-wagon

  8.  

To install:

  1. Position the module into place.
  2.  
  3. Install and tighten the mounting fasteners.
  4.  
  5. Connect the wire harness connectors and antenna cable to antenna module.
  6.  
  7. Install the liftgate trim.
  8.  
  9. Connect the battery negative cable.
  10.  

 
label.common.footer.alt.autozoneLogo