300, 300C & Magnum 2006-2008, Charger 2006-2008

Mirrors

Print

Power Mirrors



Removal & Installation
Motor
  1. Disconnect and isolate the negative battery cable.
  2.  
  3. Partially remove the door trim panel as necessary to gain access to the mirror.
  4.  
  5. Remove the two push pins (2) that secure the window trim molding (1) to the front door.
  6.  
  7. Remove the window trim molding to gain access to the mirror fasteners.
  8.  
  9. Disconnect the door wire harness connector (4) from the mirror electrical connector (2).
  10.  
  11. Remove the three nuts (1) that secure the outside rearview mirror (3) to the front door.
  12.  
  13. Remove the outside rearview mirror from the front door.

    Click image to see an enlarged view

    Fig. Exploded view of the power mirror mounting

  14.  

To install:

  1. Position the outside rearview mirror (3) to the front door.
  2.  
  3. Install the three nuts (1) that secure the mirror to the front door and tighten to 60 inch lbs. (7 Nm).
  4.  
  5. Connect the door wire harness connector (4) to the mirror electrical connector (2).
  6.  
  7. Install the window trim molding (1) onto the front door.
  8.  
  9. Install the two push pins (2) that secure the window trim molding to the front door.
  10.  
  11. Install the trim panel to the inside of the front door.
  12.  
  13. Reconnect the negative battery cable
  14.  

Switch

NOTE
A battery reconnect procedure must be performed anytime the battery has been disconnected.

  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the door trim panel, as outlined in this section.
  4.  
  5. Remove the power mirror switch from the door trim panel by twisting the switch counter-clockwise.

    Click image to see an enlarged view

    Fig. Power mirror switch removal and installation

  6.  

To install:

  1. Install the power mirror switch to the door trim panel.
  2.  
  3. Connect the wire harness connectors to the switches.
  4.  
  5. Install the door trim panel, as outlined in this section.
  6.  
  7. Connect the battery negative cable.
  8.  

 
label.common.footer.alt.autozoneLogo