300, Magnum, 2005

Manifold Absolute Pressure Sensor

Print

Removal & Installation



2.7L Engine
  1. Unlock the electrical connector.
  2.  
  3. Remove electrical connector.
  4.  
  5. Turn sensor 1/4 turn counterclockwise.
  6.  
  7. Pull sensor straight up.
  8.  
  9. Remove sensor.
  10.  
  11. Inspect O-ring.
  12.  

To install:

  1. Clean MAP sensor mounting hole at intake manifold.
  2.  
  3. Check MAP sensor O-ring seal for cuts or tears.
  4.  
  5. Position sensor into intake manifold.
  6.  
  7. Rotate sensor 1/4 turn clockwise for installation.
  8.  
  9. Connect electrical connector to sensor.
  10.  
  11. Lock electrical connector.
  12.  
  13. Connect negative battery cable.

    Click image to see an enlarged view

    Fig.

  14.  

3.5L Engine
  1. Disconnect negative battery cable.
  2.  
  3. Unlock the electrical connector.
  4.  
  5. Disconnect the electrical connector.
  6.  
  7. Rotate sensor 1/4 turn clockwise.
  8.  
  9. Pull up on sensor.
  10.  
  11. Remove sensor.

    Click image to see an enlarged view

    Fig.



    Click image to see an enlarged view

    Fig.

  12.  

5.7L Engine

The Manifold Absolute Pressure (MAP) sensor (3) is mounted into the top/rear of the intake manifold (4) near the cowl/hood seal (1).

  1. Disconnect electrical connector at sensor by sliding release lock out (1). Press down on lock tab (2) for removal.
  2.  
  3. Rotate sensor 1/4 turn counter-clockwise for removal.
  4.  
  5. Check condition of sensor O-ring.
  6.  

To install:

  1. Clean MAP sensor mounting hole at intake manifold.
  2.  
  3. Check MAP sensor O-ring seal for cuts or tears.
  4.  
  5. Position sensor (3) into intake manifold.
  6.  
  7. Rotate sensor 1/4 turn clockwise for installation.
  8.  
  9. Connect electrical connector (2) to sensor (3).

    Click image to see an enlarged view

    Fig.



    Click image to see an enlarged view

    Fig.

  10.  

6.1L

The Manifold Absolute Pressure (MAP) sensor (2) is located at the rear of the intake manifold (1).

  1. Disconnect electrical connector at sensor.
  2.  
  3. Remove two sensor mounting bolts (3).
  4.  
  5. Check condition of sensor O-ring (2).
  6.  

To install:

  1. Clean MAP sensor mounting hole at rear of intake manifold.
  2.  
  3. Check MAP sensor O-ring seal (2) for cuts or tears.
  4.  
  5. Position sensor (1) into intake manifold.
  6.  
  7. Install two sensor mounting bolts (3).
  8.  
  9. Connect electrical connector to sensor.

    Click image to see an enlarged view

    Fig.

  10.  

 
label.common.footer.alt.autozoneLogo