300, Magnum, 2005

Ignition Lock Cylinder

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove bezel ignition switch ring.
  4.  
  5. Pull center console bezel loose from instrument panel.
  6.  
  7. Insert ignition key and turn to the ON position.
  8.  
  9. Depress the locking tab on the ignition switch housing.
  10.  
  11. Pull the key cylinder from the ignition switch housing.

    Click image to see an enlarged view

    Fig. Pull the key cylinder from the ignition switch housing

  12.  

To install:

  1. Install key in lock cylinder. Turn key to the ON position (retaining tab on lock cylinder can be depressed).
  2.  
  3. The shaft at the end of the lock cylinder aligns with the socket in the end of the housing. To align the socket with the lock cylinder, ensure the socket is in the -ON- position.
  4.  
  5. Align the lock cylinder with the grooves in the housing. Slide the lock cylinder into the housing until the tab sticks through the opening in the housing.
  6.  
  7. Turn key to the OFF position and remove key.
  8.  
  9. Install center console bezel to instrument panel.
  10.  
  11. Install bezel ignition switch ring.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo