300M, Concorde, Intrepid, LHS, 1998-2004

Non-Deployed Passenger Air Bag

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect and isolate the battery negative cable.
  4.  
  5. Remove the right side silencer pad.
  6.  
  7. Remove the glove box.
  8.  
  9. Remove the two inboard mounting screws to the passenger airbag just below the distribution duct and to the left of the distribution housing.
  10.  
  11. Remove the two outboard mounting screws to the passenger airbag just below the distribution duct.
  12.  
  13. Remove the two passenger airbag mounting bolts to the crosscar beam.
  14.  
  15. Disconnect the passenger airbag electrical connector.
  16.  
  17. Maneuver the passenger airbag down in a way to clear any obstacles that may impede the removal of the airbag.
  18.  

To install:

  1. Maneuver the passenger airbag up into the instrument panel in a way to clear any obstacles that may impede the installation of the airbag.
  2.  
  3. Place the passenger into the cavity of the passenger airbag door.
  4.  
  5. Install the two passenger airbag mounting bolts to the crossbar beam. Torque bolts to 103 inch lbs. (11. 6 Nm).
  6.  
  7. Connect the passenger airbag electrical connector.
  8.  
  9. Install the two inboard mounting screws to the passenger airbag just below the distribution duct and to the left of the distribution housing. Torque screws to 25 inch lbs. (2.8 Nm).
  10.  
  11. Install the two outboard mounting screws to the passenger airbag just below the distribution duct.
  12.  
  13. Torque screws to 25 inch lbs.( 2.8 Nm).
  14.  
  15. Install the glove box assembly .
  16.  
  17. Install the right side silencer.
    CAUTION
    Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.

  18.  

 
label.common.footer.alt.autozoneLogo