300M, Concorde, Intrepid, LHS, 1998-2004



This procedure tests the resistance of the level sensor itself. It does not test the level sensor circuit.

The level sensor is a variable resistor. Its resistance changes with the amount of fuel in the tank. The float arm attached to the sensor moves as the fuel level changes.

  1. To test the level sensor, connect an ohmmeter across the sensor signal and sensor ground terminals of the fuel pump module connector.
  3. Move the float lever to the positions shown in the resistance chart. Record the resistance at each point.
  5. Replace the level sensor if the resistance is not within specifications

    Click image to see an enlarged view

    Fig. Removal and installation of the fuel level sending unit