626 1999-2001

Mirrors

Print

Power Mirrors



Diagnosis & Testing
  1. Apply battery positive voltage to the power outer mirror terminals and inspect the operation of the power outer mirror.
  2.  
  3. Apply battery voltage to terminal B and ground to terminal D. The mirror should go up.
  4.  
  5. Apply battery voltage to terminal D and ground to terminal B. The mirror should go down.
  6.  
  7. Apply battery voltage to terminal F and ground to terminal D. The mirror should go left.
  8.  
  9. Apply battery voltage to terminal D and ground to terminal F. The mirror should go right.
  10.  
  11. If not as specified, replace the power outer mirror.

    Click image to see an enlarged view

    Fig. Power mirror motor terminals-626

  12.  

Removal & Installation
Mirror Motor

Specific to:

Mazda 626 1999-2002

  1. Disconnect the negative battery cable.
  2.  
  3. Raise the rear edge of the door glass about 3.5 inches from the fully lowered position.
  4.  
  5. Remove the regulator handle if equipped with a manual window.
  6.  
  7. Remove the inner garnish.
  8.  
  9. Remove the screw to remove the inner handle.
  10.  
  11. Turn over the recess cover to remove the screw.
  12.  
  13. Remove the screw.
  14.  
  15. Remove the fasteners.
  16.  
  17. Pull the front door trim to disengage clips from the body.
  18.  
  19. Pull the front door trim upward to disengage hooks B from the body.
  20.  
  21. Disconnect the trunk lid opener switch connector.
  22.  
  23. Disconnect the connector if equipped with a power window.
  24.  
  25. Disconnect the courtesy light.
  26.  
  27. Peel back the corner of the screen at the mirror location.
  28.  
  29. Unplug the connector, remove the nuts and the mirror.
  30.  

To install:

  1. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Front door trim-626

  2.  

Mirror Switch

Specific to:

Mazda 626 1999-2002

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Insert a tape-wrapped, flathead screwdriver between the power outside mirror switch and the meter hood.
  6.  
  7. Disconnect the connector and remove the power outside mirror switch.

    Click image to see an enlarged view

    Fig. Mirror switch mounting-626

  8.  

 
label.common.footer.alt.autozoneLogo