9-3 1999

Exterior Lighting

Print

Headlights



Removal & Installation
  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Remove the grille.
  4.  
  5. Undo the direction indicator screw, unplug the connector and remove the direction indicator.

    Click image to see an enlarged view

    Fig. Removing the grill (1) and undoing the direction indicator (2)

  6.  
  7. Remove the 3 screws holding the headlight.
  8.  
  9. Lift out the headlight slightly so that the headlight connector can be unplugged.

    Click image to see an enlarged view

    Fig. Removing the screws (3), disconnecting the plug (4) and removing the headlight assembly (5)

  10.  
  11. Lift out the headlight.
  12.  

To install:

  1. Installation is the reverse of removal.
  2.  
  3. Check headlight alignment and adjust as necessary

    Click image to see an enlarged view

    Fig. Headlight alignment adjusting knobs

  4.  

Tail Lights



Removal & Installation
Body Mounted
  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Unscrew the nut holding the rear edge of the side trim and fold down the trim.

    Click image to see an enlarged view

    Fig. Unscrew the nut (1) holding the rear edge of the side trim and fold down the trim

  4.  
  5. Loosen the lamp holder.
  6.  
  7. Unscrew the 4 lamp glass retaining nuts and remove the lamp cluster.

    Click image to see an enlarged view

    Fig. Unscrew the lamp glass retaining nuts (3), disconnect the plug (2) and remove the lamp cluster

  8.  

To install:

  1. Installation is the reverse of removal.
  2.  

Trunk Lid Mounted
  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Open the cover in the luggage compartment trim on the side in question.

    Click image to see an enlarged view

    Fig. Remove the fasteners (1) and open the cover in the luggage compartment trim on the side in question

  4.  
  5. Unscrew the nuts holding the lamp fitting.

    Click image to see an enlarged view

    Fig. Unscrew the nuts (2) holding the lamp fitting and disconnect the plug

  6.  
  7. Loosen the lamp holder.
  8.  

To install:

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo