9-3 1999

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Remove the glove box.

    Click image to see an enlarged view

    Fig. Removing the glove box

  4.  
  5. Remove the air duct.
  6.  
  7. Unplug the connector.
  8.  
  9. Remove the recirculation motor from the climate control unit housing by unhooking the locking tongues.
  10.  
  11. Remove the recirculation motor shaft from the wire. The wire is angled at the end and locked across a clip. Use pliers to turn the clip so that the wire can be removed.
  12.  
  13. Lift out the recirculation motor.

    Click image to see an enlarged view

    Fig. Blend air door motor (4), connector (3) and motor shaft wire (5)

  14.  

To install:

  1. Installation is the reverse of removal.
  2.  
  3. Connect the recirculation motor shaft to the wire. The wire is angled at the end and must be locked across a clip. Use a screwdriver to turn the clip so that the wire can be locked.
  4.  
  5. Press the motor into the climate control unit housing.
  6.  

 
label.common.footer.alt.autozoneLogo