9-3 1999

Rear Window Wiper/Washer Systems

Print

Removal & Installation



Washer Motor
  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Remove the wiper arm by raising the protective cover and removing the nut.
  4.  
  5. Open the boot and remove the lid trim.
  6.  
  7. Disconnect the 4-pole connector.
  8.  
  9. Remove the wiper motor retaining screws.
  10.  
  11. Remove the motor.

    Click image to see an enlarged view

    Fig. Disconnect the 4-pole connector (3), remove the wiper motor retaining screws (4) and remove the motor (5)

  12.  

To install:

  1. Installation is the reverse of removal.
  2.  
  3. When changing the rear window wiper motor, move the rubber dampers from the old motor to the new one.
  4.  

Wiper Washer
  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Empty the reservoir.
  4.  
  5. Remove the filler pipe and the plastic nut.
  6.  
  7. Raise and safely support the vehicle.
  8.  
  9. Remove the wing liner at the front (3 screws).
  10.  
  11. Remove the pump and the level sensor from the reservoir and let them hang by their respective hoses and leads.
  12.  
  13. Remove the 2 retaining screws from the reservoir and pull the washer fluid reservoir downwards.

    Click image to see an enlarged view

    Fig. Remove the pump and the level sensor (4) and remove the retaining screws (5)

  14.  

To install:

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo