Acura CL Integra NSX RL RSX TL TSX 2001-2006

Control Cables

Print

Adjustment



Heater Valve Side
  1. Open the cable clamp, then disconnect the heater valve cable from the heater valve arm.
  2.  
  3. Turn on the A/C but do not turn the engine ON .
  4.  
  5. Set the control dial to the MAX COOL position.
  6.  
  7. Set the heater valve arm to the fully closed position.
  8.  
  9. Connect the heater valve cable to the heater valve arm.
  10.  
  11. Position the heater valve arm in the closed position.
  12.  
  13. Pull on the heater valve cable to remove any slack.
  14.  
  15. Install the cable housing into the cable clamp.
  16.  

Heater Unit Side
  1. Disconnect the heater valve cable housing at the heater unit.
  2.  
  3. Disconnect the heater valve cable from the temperature control arm.
  4.  
  5. Set the air mix control motor selector to the MAX COOL position.
  6.  
  7. Connect the heater valve cable to the temperature control arm as shown.
  8.  
  9. Hold the heater valve cable housing to the stop.
  10.  
  11. Position the heater valve cable housing into the cable clamp.
  12.  

Removal & Installation



Temperature Control Cable
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the heater and A/C control head.
  4.  
  5. Remove the trim panel, as necessary.
  6.  
  7. Unfasten the screw and/or retaining clip(s) securing the cable, then remove the temperature control cable from the vehicle.
  8.  

To install:

  1. Properly route the temperature control cable to the control head.
  2.  
  3. Install the retaining clip(s) and/or screw.
  4.  
  5. Install the trim panel.
  6.  
  7. Install the control head.
  8.  
  9. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo