See Figures 1, 2, 3, 4, 5 and 6
Your Acura comes equipped with a scissors jack. This jack is fine for changing a flat tire or other operations where you do not have to go beneath the vehicle. There are four lifting points where this jack may be used: one behind each front wheel well and one in front of each rear wheel well in reinforced sheet metal brackets beneath the rocker panels.
A more convenient way of jacking is the use of a garage or floor jack. You may use the floor jack beneath any of the four scissors jacking points or you can raise either the entire front or entire rear of the vehicle using the special jacking brackets beneath the front center or rear center of the vehicle. On station wagon models, the rear of the vehicle may be jacked beneath the center of the rear axle beam.
The following safety points cannot be overemphasized:
If you are going to have your Acura serviced on a garage hoist, make sure the four hoist platform pads are placed beneath the scissors jacking brackets. These brackets are reinforced and will support the weight of the entire vehicle.