Acura Coupes and Sedans 1994-2000 Repair Information

Brake Light Switch

Print

REMOVAL & INSTALLATION



See Figure 1

Click image to see an enlarged view

Fig. Fig. 1: The brake light switch is mounted on the brake pedal

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the brake light switch connector.
  4.  
  5. Loosen the holding nut.
  6.  
  7. Remove the brake light switch by unscrewing it in a counter-clockwise direction.
  8.  

To install:
  1. Screw in the brake light switch and adjust the plunger until it is fully depressed against the back of the brake pedal.
  2.  
  3. Back off the switch one quarter turn to allow 0.01 in (0.3mm) of clearance between the threaded and the pad.
  4.  
  5. Attach the brake light switch connector.
  6.  
  7. Connect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo