//bottom ads

Acura Coupes and Sedans 1994-2000 Repair Information

Power Brake Booster

Print

REMOVAL & INSTALLATION



See Figure 1

Click image to see an enlarged view

Fig. Fig. 1: The power brake booster is the large circular canister that the master cylinder is bolted to

  1. Disconnect the negative battery cable.
  2.  
  3. Detach all electrical connectors from the master cylinder.
  4.  
  5. Remove the brake fluid from the master cylinder, then use a flare nut wrench to disconnect.
  6.  


WARNING
Be careful not to bend the lines upon removal of the master cylinder.

  1. Remove the master cylinder from the brake booster.
  2.  
  3. Disconnect the vacuum hoses from the brake booster.
  4.  
  5. On the Vigor models, remove the throttle cable clamp bolt.
  6.  
  7. Remove the clevis and clevis pin from the brake pedal.
  8.  
  9. Remove the booster mounting bolts.
  10.  
  11. Remove the brake booster from the engine compartment.
  12.  

To install:
  1. Install the power brake booster in the reverse order of removal.
  2.  
  3. Fill the master cylinder with Honda approved or equivalent DOT 3 or DOT 4 brake fluid.
  4.  
  5. Properly bleed the master cylinder.
  6.  

 
label.common.footer.alt.autozoneLogo