Acura Coupes and Sedans 1994-2000 Repair Information

Windshield Wiper Motor

Print

REMOVAL & INSTALLATION Front



See Figures 1 through 8

Click image to see an enlarged view

Fig. Fig. 1: Matchmark the wiper arm to the shaft. This will allow you to install the arm on the splined shaft in the correct position



Click image to see an enlarged view

Fig. Fig. 2: Once the arm is matchmarked, you can pull of off the shaft



Click image to see an enlarged view

Fig. Fig. 3: Use a small prytool to pop up the plastic fasteners



Click image to see an enlarged view

Fig. Fig. 4: After removing all of the retainers, pull the air scoop away from the windshield



Click image to see an enlarged view

Fig. Fig. 5: Loosen and remove the wiper motor linkage mounting bolts ...



Click image to see an enlarged view

Fig. Fig. 6: ... then remove the wiper motor and linkage assembly from the vehicle



Click image to see an enlarged view

Fig. Fig. 7: Unfasten the wiper motor mounting nuts ...



Click image to see an enlarged view

Fig. Fig. 8: ... then remove the wiper motor from the linkage assembly

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the cap nuts and wiper arms.
  4.  
  5. Remove the hood seal.
  6.  
  7. Remove the air scoop by prying it out of the trim clips.
  8.  
  9. Remove the connector from the wiper molding.
  10.  
  11. Remove the mounting bolts.
  12.  
  13. Disconnect and remove the wiper linkage assembly.
  14.  
  15. Remove the wiring harness from the linkage assembly.
  16.  
  17. Separate the wiper linkage and the crank arm at the joint.
  18.  
  19. Unfasten the three mounting bolts that hold the wiper motor to the mount, then remove the wiper motor.
  20.  
  21. Installation is the reverse of the removal procedure.
  22.  

Rear

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the cover, mounting nut, and wiper.
  4.  
  5. Remove the rubber seal.
  6.  
  7. Unfasten the special nut and remove the washer.
  8.  
  9. Remove any trim panels that hinder removal.
  10.  
  11. Detach the wiring connector from the wiper motor.
  12.  
  13. Remove the motor mounting bolts, then remove the motor assembly.
  14.  
  15. Installation is the reverse of the removal procedure.
  16.  

 
label.common.footer.alt.autozoneLogo