Acura_MDX_2001-2006

Control Assembly

Print

Removal & Installation



2001-02 Models
  1. Remove the console rear trim. Refer to the accompanying illustration.

    Click image to see an enlarged view

    Fig. Exploded view of the console rear trim

  2.  
  3. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B).
  4.  

To install:

  1. Install the control unit in the reverse order of removal. After installation, operate the control unit controls to see whether it works properly.
  2.  
  3. Run the self-diagnosis function to confirm that there are no problems in the system.

    Click image to see an enlarged view

    Fig. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B)

  4.  

2003-06 Models
  1. Remove the console rear trim, as follows:
    1. Remove both vents (A). Reach into the air vents holes as shown, grab the console rear trim (B) and pull it out. Then disconnect the rear heater-A/C passenger's control panel-unit connector (C).

      Click image to see an enlarged view

      Fig. Remove both vents (A). Reach into the air vents holes as shown, grab the console rear trim (B) and pull it out. Then disconnect the rear heater-A/C passenger's control panel-unit connector (C)

    2.  

  2.  
  3. Remove the self-tapping screws and the rear heater-A/C control panel-unit from the console rear trim.
  4.  
  5. Install the control unit in the reverse order of removal. After installation, operate the control unit controls to see if they work properly.
  6.  

 
label.common.footer.alt.autozoneLogo