Altima 2007-2009

Removal & Installation

Print

Left Side



Specific to:

Nissan Altima 2007-2008

  1. Remove the instrument lower cover LH. Refer to the Instrument Panel procedure in the Body Section.
  2.  
  3. Remove the center console side finisher LH. Refer to the Instrument Panel procedure in the Body Section.
  4.  
  5. Remove the heater and cooling unit foot duct LH (2).
  6.  
  7. Remove the tire pressure monitoring system receiver.
  8.  
  9. Disconnect the air mix door motor connector (1).
  10.  
  11. Remove the air mix door motor screws (A) and then remove the air mix door motor LH.

    Click image to see an enlarged view

    Fig. Disconnect the air mix door motor connector (1). Remove the air mix door motor screws (A) and then remove the LH air mix door motor

  12.  
  13. Installation is the reverse of the removal procedure.
  14.  

Specific to:

Nissan Altima 2009-2010

  1. Remove the instrument lower cover LH.
  2.  
  3. Remove the center console side finisher LH.
  4.  
  5. Remove the heater and cooling unit foot duct LH.

    Click image to see an enlarged view

    Fig. Remove the heater and cooling unit foot duct LH (2); disconnect the air mix door motor connector (1); remove the air mix door motor screws (A)

  6.  
  7. Remove the tire pressure monitoring system receiver.
  8.  
  9. Disconnect the air mix door motor connector.
  10.  
  11. Remove the air mix door motor screws and then remove the air mix door motor LH.
  12.  

To install:

  1. Installation is in the reverse order of removal.
  2.  

Right Side



Specific to:

Nissan Altima 2007-2008

  1. Open the glove box door (1), remove the glove box assembly screws (A).

    Click image to see an enlarged view

    Fig. Open the glove box door (1), remove the glove box assembly screws (A)

  2.  
  3. Remove the glove box assembly lower screws (A), then remove the glove box assembly.

    Click image to see an enlarged view

    Fig. Remove the glove box assembly lower screws (A), then remove the glove box assembly

  4.  
  5. Remove the heater and cooling unit foot duct LH (2).
  6.  
  7. Disconnect the air mix door motor connector (1).
  8.  
  9. Remove the air mix door motor screws (A) and then remove the air mix door motor RH.
  10.  
  11. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Disconnect the air mix door motor connector (1), then remove the air mix door motor screws (A) and the RH air mix door motor

  12.  

Specific to:

Nissan Altima 2009-2010

  1. Remove the glove box.
  2.  
  3. Remove the heater and cooling unit foot duct RH.

    Click image to see an enlarged view

    Fig. Remove the heater and cooling unit foot duct RH (2); disconnect the air mix door motor connector (1); remove the air mix door motor screws (A)

  4.  
  5. Disconnect the air mix door motor connector.
  6.  
  7. Remove the air mix door motor screws and then remove the air mix door motor RH.
  8.  

To install:

  1. Installation is in the reverse order of removal.
  2.  

 
label.common.footer.alt.autozoneLogo