Altima 2007-2009

High Voltage Battery Blower Motor

Print

Removal & Installation




CAUTION
Before beginning service, thoroughly review ALL of the High Voltage (HV) system and general precautions at the beginning of this section. Failure to do so can result in serious personal injury or death.

  1. Remove the rear seat, as follows:
    1. Remove the rear seat cushion trim and pad, by pulling the lock at the front bottom of the seat cushion forward (one for each side), and pull the seat cushion upward to release the wire from the plastic hook, then pull the seat cushion forward to remove.

      Click image to see an enlarged view

      Fig. Pull the lock at the front bottom of the seat cushion forward (one for each side), and pull the seat cushion upward to release the wire from the plastic hook, then pull the seat cushion forward to remove

    2.  
    3. Remove the seatback hinge anchor bolts.
    4.  
    5. Lift the seatback off rear parcel panel front hangers and remove the seatback assembly.
    6.  

  2.  
  3. Remove the rear parcel shelf finisher.
  4.  


    Click image to see an enlarged view

    Fig. Exploded view of trunk room trim

  5. Remove the trunk room trim.
  6.  
  7. Remove the upper and lower inlet duct clips and bolts.
  8.  
  9. Remove the upper and lower inlet duct from the package shelf and HV battery blower motor.
  10.  
  11. Remove the front duct clip and remove the front duct from the rear upper duct and HV battery assembly.
  12.  
  13. Separate the rear upper duct from the rear lower duct and remove the rear upper duct from the HV battery blower motor.
  14.  
  15. Disconnect the HV battery blower motor harness connector from the HV battery blower motor.
  16.  
  17. Remove the HV battery blower motor from the HV battery assembly.
  18.  
  19. Installation is the reverse of the removal procedure.

    Click image to see an enlarged view

    Fig. Exploded view of the HV battery blower motor and related components

  20.  

 
label.common.footer.alt.autozoneLogo