Altima 2007-2009

Windshield Washer Systems

Print

Removal & Installation



Washer

Specific to:

Nissan Altima 2009-2010

Front washer pump is not available separately, it is part of the washer tank.

  1. Remove the washer tank filler tube.

    Click image to see an enlarged view

    Fig. Remove the washer tank filler tube (1)

  2.  
  3. Remove engine under cover.
  4.  
  5. Position the RH fender protector back.
  6.  
  7. Disconnect the washer pump and washer fluid level sensor connectors, then detach the connector harness clip.

    Click image to see an enlarged view

    Fig. Disconnect the washer pump and washer fluid level sensor connectors, then detach the connector harness clip

  8.  
  9. Remove the washer tank nuts, disconnect the washer pump hose and remove the washer tank.
  10.  

To install:

  1. Installation is in the reverse order of removal.
    CAUTION
    After installation, add Nissan specified fluid up to the upper level of washer tank inlet, and check for leaks.

  2.  

Washer Motor

Specific to:

Nissan Altima 2007-2008


NOTE
The washer pump not serviceable as a separate component, it is replaced as part of the washer tank.

  1. Remove the washer tank filler tube (1).

    Click image to see an enlarged view

    Fig. Remove the washer tank filler tube (1)

  2.  
  3. Remove engine under cover.
  4.  
  5. Position the RH fender protector back, as follows:
    1. Remove the screw from center mudguard.
    2.  
    3. Remove the fender protector screws and clips.
    4.  
    5. Remove the fender protector.
    6.  

  6.  
  7. Disconnect the washer pump and washer fluid level sensor connectors (C), then detach the connector harness clip (B).
  8.  
  9. Remove the washer tank nuts (A), disconnect the washer pump hose and remove the washer tank (1).

    Click image to see an enlarged view

    Fig. Disconnect the washer pump and washer fluid level sensor connectors (C), then detach the connector harness clip (B). Remove the washer tank nuts (A), disconnect the washer pump hose and remove the washer tank (1)

  10.  

To install:

  1. Installation is in the reverse order of removal.
  2.  
  3. After installation, add Nissan specified fluid up to the upper level of washer tank inlet, and check for leaks
  4.  

 
label.common.footer.alt.autozoneLogo