Removal & Installation
- Remove the RWAL valve harness connector from the controller.
- Remove the brake lines from the valve.
- Remove the valve mounting bolt and remove the valve from the bracket.
Installation is the reverse of removal. Tighten the mounting bolt to 15-20 ft. lbs. (20-27 Nm). Tighten the brake line fittings to 14 ft. lbs. (19 Nm).
The assembly is located on the driver-s side inner fender under the hood. The assembly modulates hydraulic pressure to the rear brakes during a RWAL (Rear Wheel Anti-Lock) stop.