Aspen 2007, Durango 2005-2007

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the center bezel from the instrument panel, disconnect the wire harness connector(s) from the A/C-heater control and place the center bezel on a workbench.
  4.  
  5. Remove the four screws that secure the A/C heater control to the instrument panel center bezel.
  6.  
  7. Remove the A/C heater control from the instrument panel center bezel.

    Click image to see an enlarged view

    Fig. Two screws retain the center bezel to the instrument panel.



    Click image to see an enlarged view

    Fig. Four screws (1) retain the control panel (2) to the center bezel (3).

  8.  

to install:

  1. Position the A/C heater control into the instrument panel center bezel.
  2.  
  3. Install the screws that secure the A/C heater control to the instrument panel center bezel. Tighten the screws to 2 Nm (17 inch lbs.).
  4.  
  5. Connect the wire harness connector(s) to the A/C heater control and install the instrument panel center bezel.
  6.  
  7. Reconnect the negative battery cable.
  8.  

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the center bezel from the instrument panel, disconnect the wire harness connector(s) from the A/C-heater control and place the center bezel on a workbench.
  4.  
  5. Remove the four screws that secure the A/C heater control to the instrument panel center bezel.
  6.  
  7. Remove the A/C heater control from the instrument panel center bezel.

    Click image to see an enlarged view

    Fig. Two screws retain the center bezel to the instrument panel.

  8.  

Four screws (1) retain the control panel (2) to the center bezel (3).

to install:

  1. Position the A/C heater control into the instrument panel center bezel.
  2.  
  3. Install the screws that secure the A/C heater control to the instrument panel center bezel. Tighten the screws to 2 Nm (17 inch lbs.).
  4.  
  5. Connect the wire harness connector(s) to the A/C heater control and install the instrument panel center bezel.
  6.  
  7. Reconnect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo