Aspen 2007, Durango 2005-2007

Mirrors

Print

Power Mirrors



Diagnosis & Testing

Any diagnosis of the Power Mirror system should begin with the use of scan tool. For information on the use of the scan tool, refer to the appropriate Diagnostic Service information.


NOTE
For complete circuit diagrams, refer to the appropriate wiring information.

  1. Check the fuses in the Power Distribution Center (PDC) and the junction block. If OK, go to Step 2. If not OK, repair the shorted circuit or component as required and replace the faulty fuse(s).
  2.  
  3. Check for battery voltage at the fuse in the junction block. If OK, go to Step 3. If not OK, repair the open circuit to the PDC as required.
  4.  
  5. Disconnect and isolate the battery negative cable. Remove the driver side power window switch and bezel assembly and unplug the wire harness connector from the power mirror switch. Connect the battery negative cable. Check for battery voltage at the fused B(+) circuit cavity in the door wire harness half of the power mirror switch wire harness connector. If OK, go to Step 4. If not OK, repair the open circuit to the junction block as required.
  6.  
  7. Disconnect and isolate the battery negative cable. Check for continuity between the ground circuit cavity in the door wire harness half of the power mirror switch wire harness connector and a good ground. There should be continuity. If not OK, repair open in the ground circuit.
  8.  

Removal & Installation
Motor

The power mirror motor is integral to the mirror assembly.

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect and isolate the negative battery cable.
  4.  
  5. Remove the trim panel from the inside of the front door
  6.  
  7. Remove the two push pins that secure the window trim molding to the front door.
  8.  
  9. Remove the window trim molding to gain access to the mirror fasteners.
  10.  
  11. Disconnect the door wire harness connector from the mirror electrical connector.
  12.  
  13. Remove the three nuts that secure the outside rearview mirror to the front door.
  14.  
  15. Remove the outside rearview mirror from the front door.

    Click image to see an enlarged view

    Fig. Outside rearview mirror mounting

  16.  

To install:

  1. Position the outside rearview mirror to the front door.
  2.  
  3. Install the three nuts that secure the mirror to the front door. Tighten the nuts to 60 inch. lbs. (7 Nm).
  4.  
  5. Connect the door wire harness connector to the mirror electrical connector.
  6.  
  7. Install the window trim molding onto the front door.
  8.  
  9. Install the two push pins that secure the window trim molding to the front door.
  10.  
  11. Install the trim panel to the inside of the front door.
  12.  
  13. Reconnect the negative battery cable.
  14.  

Switch

Refer to the Power Door Lock Switch removal and installation procedure.

 
label.common.footer.alt.autozoneLogo