Aspen 2007, Durango 2006-2007

Control Module

Print

Removal & Installation




NOTE
If the Anti-Lock Brake Module (ABM) is being replaced with a new ABM it must be reprogrammed with the use of a scan tool.

  1. Remove the HCU from the vehicle
  2.  
  3. Remove the module mounting screws.
  4.  
  5. Disconnect the pump electrical connector from the HCU.
  6.  
  7. Remove the module from the HCU.
  8.  

To install:

  1. Position the module on the HCU.
  2.  
  3. Install the mounting screws and tighten to 6 Nm (53 in. lbs).
  4.  
  5. Install the pump electrical connector to the module.
  6.  
  7. Install the HCU to the vehicle.
  8.  

 
label.common.footer.alt.autozoneLogo