Aspen 2007, Durango 2006-2007

Rear Main Seal

Print

Removal & Installation



3.7L & 4.7L Engines
  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flexplate
     

  4.  
  5. Thread Oil Seal Remover 8506 into the rear main seal as far as possible and remove the rear main seal.
  6.  

To install:

  1. Install or connect the following:

    Seal Guide 8349-2 onto the crankshaft
     
    Rear main seal on the seal guide
     
    Rear main seal, using the Crankshaft Rear Oil Seal Installer 8349 and Driver Handle C-4171; tap it into place until the installer is flush with the cylinder block
     
    Flexplate. Tighten the bolts to 45 ft. lbs. (60 Nm) for 4.7L; 70 ft. lbs. (95 Nm) for the 3.7L engine.
     
    Transmission
     

  2.  
  3. Start the engine and check for leaks.
  4.  

5.7L Engines
  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Disconnect negative cable from battery.
  4.  
  5. Remove the transmission.
  6.  
  7. Remove the flexplate.
  8.  
  9. Remove the oil pan.
  10.  
  11. Remove the rear oil seal retainer mounting bolts.
  12.  
  13. Carefully remove the retainer from the engine block.
  14.  
  15. Using a seal puller, remove the crankshaft rear oil seal.
  16.  

To install:

Click image to see an enlarged view

Fig. Rear seal retainer torque sequence-5.7L engine


NOTE
The rear seal must be installed dry for proper operation. Do not lubricate the seal lip or outer edge.

  1. Position the plastic seal guide onto the crankshaft rear face. Then position the crankshaft rear oil seal onto the guide.
  2.  
  3. Using a seal driver and hammer, tap the seal into place. Continue to tap on the driver handle until the seal installer seats against the cylinder block crankshaft bore.
  4.  
  5. Thoroughly clean all gasket residue from the engine block.
  6.  
  7. Use extreme care and clean all gasket residue from the retainer.
  8.  
  9. Position the gasket onto the retainer.
  10.  
  11. Position the retainer onto the engine block.
  12.  
  13. Install the retainer mounting bolts. Tighten the bolts to 132 inch lbs. (15 Nm).
  14.  
  15. Install the oil pan.
  16.  
  17. Install the flexplate. Tighten to 70 ft. lbs. (95 Nm).
  18.  
  19. Install the transmission.
  20.  
  21. Check and verify engine oil level.
  22.  
  23. Start engine and check for leaks.
  24.  

 
label.common.footer.alt.autozoneLogo