Aspen 2007, Durango 2006-2007

Throttle Body

Print

Removal & Installation



3.7L & 4.7L Engines
  1. Remove the air cleaner assembly.
  2.  
  3. Perform the fuel system depressurization procedure.
  4.  
  5. Disconnect the battery negative cable.
  6.  
  7. Disconnect all vacuum lines and electrical connectors from the throttle body. Tag for location, if necessary. Electrical connectors include TPS, MAP and IAC motor.
  8.  
  9. Disconnect cables: throttle, cruise control and others fitted.
  10.  
  11. Remove the throttle body bolts.
  12.  
  13. Lift the throttle body from the intake manifold.
  14.  
  15. Put a clean rag into the intake manifold to prevent the entry of foreign matter.
  16.  

To install:

  1. Always use a new gasket. Inspect the O-ring between the throttle body and intake manifold.
  2.  
  3. Reverse the removal procedure.
  4.  
  5. Tighten the throttle body bolts to 9 ft. lbs. (12 Nm).

    Click image to see an enlarged view

    Fig. Throttle body and mounting bolts-3.7L and 4.7L engines



    Click image to see an enlarged view

    Fig. Inspect throttle body O-ring and replace if necessary

  6.  

5.7L Engine
  1. Remove air duct and air resonator box at throttle body.
  2.  
  3. Disconnect electrical connector at throttle body.
  4.  
  5. Remove four throttle body mounting bolts.
  6.  
  7. Remove throttle body from intake manifold.

    Click image to see an enlarged view

    Fig. The 5.7L throttle body employs four mounting bolts



    Click image to see an enlarged view

    Fig. Inspect the o-ring before installing the throttle body

  8.  

To install:

  1. Clean and check condition of throttle body-to-intake manifold o-ring.
  2.  
  3. Clean mating surfaces of throttle body and intake manifold.
  4.  
  5. Install throttle body to intake manifold by positioning throttle body to manifold alignment pins.
  6.  
  7. Install 4 mounting bolts.
  8.  
  9. Install electrical connector.
  10.  
  11. Install air plenum.
    NOTE
    A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.


    NOTE
    If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set. If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTCs) from ECM.

  12.  

 
label.common.footer.alt.autozoneLogo