Removal & Installation
- Use a suitable clean, smooth, thin flat-bladed prytool and carefully release the lens from the light assembly to access the bulbs.
- Once released, remove the bulb(s) from their retainer(s) and replace as necessary.
- Installation is the reverse of the removal procedure.
- Note: If the bulbs are seized in place if installed, remove the Phillips fasteners, release the retainers and remove the assembly. To remove the small pressed in bulbs, access the bulb holder from the back of the assembly and turn counterclockwise to remove the bulb holder. The bulb can then be pulled out of the holder.
On instrument clusters installed on these models, only the control light bulbs are replaceable. Should any other failure occur, the instrument cluster must be replaced.