Aura, Outlook 2007

Removal & Installation

Imprimir

  1. Remove the fuse labeled HVAC CTRL (BATT).
  2.  
  3. Completely open the instrument panel compartment door by pressing both tabs that support the stop bumpers.
  4.  
  5. Disconnect the air temperature actuator electrical connector.
  6.  
  7. Remove the Air Temperature Actuator screw and the actuator.
  8.  

To install:

  1. Installation is the reverse of removal.
    NOTE
    Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.

  2.  

Left Side



  1. Remove the instrument panel insulator - right side.
  2.  
  3. Remove the glove box.
  4.  
  5. Remove the Air Temperature Actuator screw and the actuator.
  6.  

To install:

  1. Installation is the reverse of removal.
  2.  

Right Side



  1. Remove the instrument panel insulator - right side.
  2.  
  3. Remove the glove box.
  4.  
  5. Remove the Air Temperature Actuator screw and the actuator.
  6.  

To install:

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo