Aura, Outlook 2007

Removal & Installation

Print

  1. Remove the fuse labeled HVAC CTRL (BATT).
  2.  
  3. Remove the left closeout panel.
  4.  
  5. Remove the knee bolster.
  6.  
  7. Disconnect the mode actuator electrical connector
  8.  
  9. Remove the Mode Actuator screw and the actuator.
  10.  

To install:

  1. Installation is the reverse of removal.
    NOTE
    Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.

  2.  

  1. Remove the instrument panel insulator - right side.
  2.  
  3. Remove the glove box.
  4.  
  5. Remove the mode actuator screw and actuator.
  6.  

To install:

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo