Aura, Outlook 2007

Removal & Installation

Print

  1. Remove the fuse labeled HVAC CTRL (BATT).
  2.  
  3. Remove the right closeout panel.
  4.  
  5. Remove the communications interface module.
  6.  
  7. Remove the OnStar module bracket. Disconnect the recirculation actuator electrical connector.
  8.  
  9. Remove the Recirculation Actuator screw and actuator.
  10.  

To install:

  1. Installation is the reverse of removal.
    NOTE
    Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.

  2.  

  1. Remove the instrument panel insulator - right side.
  2.  
  3. Remove the glove box.
  4.  
  5. Remove the Recirculation Actuator screw and actuator.
  6.  

To install:

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo