Aurora 2001-2003

Yaw Rate Sensor

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
    NOTE
    Always turn the ignition OFF when connecting or disconnecting battery cables, battery chargers, or jumper cables. Failing to do so may damage the Powertrain Control Module (PCM) or other electronic components.


    NOTE
    The battery is located beneath the rear seat cushion.

  4.  
  5. Turn OFF the ignition.
  6.  
  7. Remove or disconnect the following:

    2 yaw rate sensor mounting nuts
     
    Yaw rate sensor
     
    Yaw rate sensor electrical connector

    Click image to see an enlarged view

    Fig. Location of yaw rate sensor.

     

  8.  

To install:

  1. Install or connect the following:

    Yaw rate sensor electrical connector
     
    Yaw rate sensor and tighten the nuts to 53 inch lbs. (6 Nm)
     

  2.  
  3. Perform the ABS Diagnostic System Check.
  4.  

 
label.common.footer.alt.autozoneLogo