Avalanche, Express, Savana 2006-2007

Fuel System Purging

Print

Bleeding



  1. Prior to priming the engine, ensure that the following has been completed:

    There is fuel in the fuel tank
     
    The fuel filter has been installed and properly tightened
     
    The fuel lines are properly connected
     
    The fuel filter is cool to the touch
     
    Any dirt or debris has been removed from the fuel filter head and vent valve
     

  2.  
  3. Turn the ignition key on for two minutes.
  4.  
  5. The fuel pump will be operating and starting the priming process. Do not start the engine during the first two minutes.
  6.  
  7. After completing the initial prime, turn the ignition off, then back to start and crank the engine for 15 seconds.
  8.  
  9. If the engine does not start, repeat the previous steps until the engine starts.
  10.  
  11. If the engine does not run after repeating the steps three times, turn the ignition key OFF for 60 seconds, allowing the Electronic Control Module (ECM) to reset.
  12.  
  13. Repeat the above steps until the engine starts.
  14.  
  15. If the engine runs, but does not run smoothly, increase the engine speed slightly by pressing the accelerator pedal. This will help to force out air through the system.
  16.  
  17. If the engine starts and runs but stalls again, turn the ignition key OFF for 60 seconds to reset the ECM and repeat the steps above.
  18.  
  19. Start the engine and allow it to idle for a few minutes.
  20.  
  21. Check the filter for leaks.
  22.  
  23. Check for fuel leaks and clear all Diagnostic Trouble Codes (DTCs).
  24.  

 
label.common.footer.alt.autozoneLogo