Avalanche, Express, Savana 2006-2007

Distributor Cap & Rotor

Print

Removal & Installation



  1. Make sure ignition switch in I the OFF position.
  2.  
  3. Remove the engine cover.
  4.  
  5. If the distributor cap is going to be replaced tag (number) and disconnect the ignition wires from distributor cap.
  6.  
  7. Remove the two screws holding the distributor cap to the housing and remove distributor cap.
  8.  
  9. Remove the two screws holding the rotor and remove the rotor.
    1. Note which holes in the rotor the screws are removed from.
    2.  

  10.  

To install:

  1. Install the rotor and tighten the screws.
  2.  
  3. Install the distributor cap and tighten the screws to 21 inch lbs. (2.4 Nm).
  4.  
  5. If removed, reconnect ignition wires.
    1. Observe the tags (numbering) to make sure the ignition wires are reconnected to the proper sockets on the distributor cap.
    2.  

  6.  
  7. Install the engine cover.
  8.  

 
label.common.footer.alt.autozoneLogo