Removal & Installation
Remove or disconnect the following:
2 / 3 of the brake fluid from the master cylinder
Using a C-clamp or the equivalent, compress the caliper piston until the caliper piston bottoms in the bore.
Brake hose at caliper by removing the inlet fitting bolt. Plug the line.
Inspect the caliper assembly.
Install or connect the following:
Caliper. Tighten the caliper guide pin bolts to 74 ft. lbs. (100 Nm) on 1500 series or 80 ft. lbs. (108 Nm) on 2500 series.
Bleed the brakes.
Tire and wheel assembly