Avenger 2008

Brake System Bleeding

Print


NOTE
For bleeding the ABS hydraulic system, refer to Antilock Brake System Bleeding in the Antilock Brake System section.


CAUTION
Before removing the master cylinder cap, wipe it clean to prevent dirt and other foreign matter from dropping into the master cylinder reservoir.


CAUTION
Use only Mopar® brake fluid or an equivalent from a fresh, tightly sealed container. Brake fluid must conform to DOT 3 specifications.

Do not pump the brake pedal at any time while having a bleeder screw open during the bleeding process. This will only increase the amount of air in the system and make additional bleeding necessary.

Do not allow the master cylinder reservoir to run out of brake fluid while bleeding the system. An empty reservoir will allow additional air into the brake system. Check the fluid level frequently and add fluid as needed.

The following wheel circuit sequence for bleeding the brake hydraulic system should be used to ensure adequate removal of all trapped air from the hydraulic system:



Left rear wheel
 
Right front wheel
 
Right rear wheel
 
Left front wheel
 

 
label.common.footer.alt.autozoneLogo