Avenger 2008

Mirrors

Print

Power Mirrors



Removal & Installation
Mirror Motor

Specific to:

Chrysler Sebring 2008-2009

Dodge Avenger 2008-2009

  1. Using trim stick C-4755, remove side view mirror flag.
    1. Gently pry upward on trim panel disengaging trim clips from door (1).

      Click image to see an enlarged view

      Fig. Remove mirror flag (2) from door (1)

    2.  
    3. Remove mirror flag (2) from door (1).
    4.  

  2.  
  3. Disconnect power window mirror motor wire connector, if equipped.
  4.  
  5. Disconnect manual mirror adjuster from side mirror cover, if equipped.
  6.  
  7. Remove nuts attaching side view mirror to mirror flag.

    Click image to see an enlarged view

    Fig. Remove nuts attaching side view mirror to mirror flag

  8.  
  9. Remove side view mirror from vehicle.
  10.  

To install:

  1. Feed power mirror wire harness through hole in mirror flag and seat grommet. Do not pull on wire harness to seat grommet, if so equipped.
  2.  
  3. Position side view mirror to vehicle.
  4.  
  5. Install nuts attaching side view mirror to mirror flag.
  6.  
  7. Engage push in fastener attaching power mirror wire connector to inner door panel, if equipped.
  8.  
  9. Engage power mirror motor wire connector.
  10.  
  11. Install side view mirror Flag.
  12.  

Mirror Switch

Specific to:

Chrysler Sebring 2008-2009

Dodge Avenger 2008-2009

  1. Disconnect and isolate the battery negative remote cable.
  2.  
  3. Remove door trim panel.
    NOTE
    Sedan door shown, convertible door similar.



    Click image to see an enlarged view

    Fig. Sedan door

    1. Remove side view mirror flag.
    2.  
    3. Open the access cover behind the interior door handle and remove the screw (1).
    4.  
    5. Open access cover on the inside pull handle and remove fasteners (2).
    6.  
    7. Using trim stick C-4755 or equivalent, gently pry trim panel away from door.
    8.  
    9. Disconnect the interior door handle cable.
    10.  
    11. Disconnect electrical connectors and remove door trim panel.
    12.  

  4.  
  5. Disconnect switch wire connector.
  6.  
  7. Remove switch assembly.
  8.  

To install:

  1. Install the switch by snapping into place.
  2.  
  3. Connect switch wire connector.
  4.  
  5. Install the door trim panel.
  6.  
  7. Connect the battery negative remote cable.
  8.  

 
label.common.footer.alt.autozoneLogo