Aveo 2006-2007

Mirrors

Print

Power Mirrors



Diagnosis & Testing
  1. Perform a diagnostic vehicle check to check for the presence of any diagnostic trouble codes.
  2.  
  3. Inspect for aftermarket devices which could affect the operation of the system.
  4.  
  5. Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom.
  6.  
  7. Inspect fuse F1 and replace if necessary.
  8.  
  9. Turn the ignition ON , with the engine OFF and measure the voltage at fuse F1. It should be 11-14 volts. If not, the power supply circuit for the fuse must be repaired.
  10.  
  11. Remove the mirror switch and confirm that the wiring is properly connected.
  12.  
  13. Turn the ignition ON , with the engine OFF and measure the voltage at terminals 6 & 8 on the switch. It should be 11-14 volts. If not, measure the voltage at terminal 6 and ground. It should be 11-14 volts. If it is, repair the open circuit between terminal 8 and ground. If it is not, repair the open circuit between the F1 fuse and mirror switch.
  14.  

Removal & Installation
Motor
  1. Remove the front door escutcheon.
  2.  
  3. Disconnect the mirror electrical connector.
  4.  
  5. Remove the mounting screws and remove the mirror assembly from the door.
  6.  

To install:

  1. Install the outside mirror assembly and tighten the mounting screws to 40 inch lbs. (4.5 Nm).
  2.  
  3. Connect the mirror electrical connector.
  4.  
  5. Install the front door escutcheon.
  6.  

Switch
  1. From beneath the instrument panel, reach up and press one of the retaining tabs for the trim panel on the switch.
  2.  
  3. While pressing one of the retaining tabs, pull the switch assembly away from the instrument panel.
  4.  
  5. Disconnect the electrical connector.
  6.  
  7. Installation is the reverse order of removal.
  8.  

 
label.common.footer.alt.autozoneLogo